WANTED 9" DIFF MEASURING 52" FLANGE TO FLANGE WITH/WITHOUT CENTRE...... IF NO LUCK ....ARE SUPERFORMANCE OK FOR CUT DOWN DIFFS AS FREIGHT TO DARWIN HAS TO BE CONSIDERED...... CHEERS FRANKY lWANTED 9"
-
Franky
- Senior Member
- Posts: 1002
- Joined: Tue Jun 18, 2002 10:01 am
- Location: From tropical Darwin to freezing Wangaratta
WANTED 9"
WANTED 9" DIFF MEASURING 52" FLANGE TO FLANGE WITH/WITHOUT CENTRE...... IF NO LUCK ....ARE SUPERFORMANCE OK FOR CUT DOWN DIFFS AS FREIGHT TO DARWIN HAS TO BE CONSIDERED...... CHEERS FRANKY lI want to go back to Alaska, its too damm hot
Cheers Franky..........
N.T. GASSERS
Cheers Franky..........
N.T. GASSERS
-
spark
- Senior Member
- Posts: 1455
- Joined: Thu Jun 13, 2002 5:39 pm
- Location: East Gippsland
How about a 9+ Heavy duty housing kit from Sydney Competition Warehouse?
The kit has center housing, axle tubes and bearing ends.
Cut the tubes to length, assemble and weld =new rear end.
Or get the kit, the axles the center and get a diff place to shorten and respline the axles and put it together for you.
Check the add in Street Rodding- Jan, No 159, on page 96.
Sydney Competition Warehouse- phone- (02)9891 5088
The kit has center housing, axle tubes and bearing ends.
Cut the tubes to length, assemble and weld =new rear end.
Or get the kit, the axles the center and get a diff place to shorten and respline the axles and put it together for you.
Check the add in Street Rodding- Jan, No 159, on page 96.
Sydney Competition Warehouse- phone- (02)9891 5088
Danger- man with a dry sense of Humor that lives near the sea.
.
.