Okay, this is a pretty common drivetrain in hot rods so hoping someone out there has done this before and remembers the details
I am using a 283 chev and th350 in my 28 ford and have large and small th350 yokes to choose from. I am using a 6cyl centura diff.
So what tailshaft did you use and what universal joints?
Turbo 350 to centura diff
- Oldschool36
- Posts: 223
- Joined: Sun Jul 03, 2005 12:07 am
- Location: Adelaide, SA
Turbo 350 to centura diff
Steve
"Man, you got the bitchinest car in the valley"
"Man, you got the bitchinest car in the valley"
- FRANK BASILE
- Old Hand
- Posts: 13898
- Joined: Wed May 07, 2003 3:14 pm
Re: Turbo 350 to centura diff
Hi Steve. What uni joint size is on the Centura diff? . T350 splines are common to Powerglide and Trimatic . These came with varying uni joint sizes 6 or 8 cyl . My thoughts are that going for something overkill at the yolk has no advantage if the rear is smaller . You have a light vehicle and a 283 . I would go for something close to what is at the diff end
OZ-E-Rodders Rod and Kustom Club Member #31
-
- Posts: 61
- Joined: Tue Jun 17, 2014 10:08 pm
Re: Turbo 350 to centura diff
Xd falcon Uni is the same as Centura
I used a xd tail shaft chops it to length and had a t350 yoke put on the front in my A mod
I used a xd tail shaft chops it to length and had a t350 yoke put on the front in my A mod